IP70

IP70
Mini-ITX Motherboard with Intel® Pentium® N4200 Processor
Features
• Intel® Pentium® Processor N4200
• Mini ITX Form Factor ( 170 x 170 mm )
• DDR3L 1866MHz SO-DIMM support up to 8 GB
• SO-DIMM support up to 8 GB
• 12V Single Voltage Power Input
• Multi display supports DP / HDMI / LVDS / eDP (Optional) panel

System Specification

Form FactorMini-ITX
ProcessorIntel Pentium N4200 Apollo Lake Processor 1.10 GHz,
up to 2.50 GHz with turbo boost technology
BIOSInsyde BIOS
System ChipsetIntel® SOC
System Memory2 × DDR3L 1866 MHz SO-DIMM ( max. 8GB )
Graphic ChipsetIntel HD Graphics 505, supports DirectX 12 and OpenGL4.3
Ethernet ControllerIntel I210AT Gigabit-LAN Controller + I219LM Gigabit-LAN PHY
Expansion Slot1 x M.2 slot (for SSD)
1 x M.2 Slot (for WiFi)
1 x PCIE 2.0 (x1) slot (Optional)

I/O Connectors

Back Side I/O4 x USB 3.0
2 x RJ-45 for Giga LAN
1 x DP 1.2
1 x HDMI 1.4b
1 x Audio Jack (Mic-in, Line-out)
1 x (+12V) DC-in Power Jack
1 x Clear CMOS Button
1 x Reset Button
Internal I/O pin-header3 x RS-232 2x5 pin-header
1 x RS-232/422/485 2x5 pin-header
4 x USB 2.0
1 x LVDS by DF-13 40 pin connector
2 x SATA III (SATA2 is only available when M.2 SATA is not in use;
SATA2 and M.2 SATA cannot be used concurrently.)
1 x SATA power by 2x4 pin wafer
2 x -pin-header for speaker(with Amplifier): Left, Right
1 x 14-pin pin-header for DIO
1 x 3-pin digital panel backlight brightness controller
1 x 7-pin inverter
1 x 2x2-pin DC-in 12V connector
2 x 2-pin wafer for +5V external power (Red)
1 x 2-pin wafer for 12V external power (Yellow)
1 x OSD membrane control
1 x eDP panel by JAE-FI-X30S-HF 30p connector (Optional)
1 x 10-pin wafer for VGA output(Optional)

Audio Specification

Audio ControllerRealtek HD codec

Mechanical & Environment Specification

Dimensions ( L x W )170 mm x 170 mm ( Mini-ITX Form Factor )
Power Input+12V Power Input
Operating Temperature-20 ~ +60°C
Operating Humidity10 ~ 95%, non-condensing
Storage Temperature-40 ~ +70°C
  • All specifications are subject to change without prior notice!
    *If you use SBC on-board RS485, you need to set appropriate state of RTS line before sending/receiving data in your software program.We offer additional board that can perform auto-direction hardware function.