Front IP65 Panel Mount

The devices sealed to IP65 from the front side have a special rubber (O-ring) on the rear of front bezel. The device is mounted from the front side and secured from the rear side.

Front IP65 Panel PC has a special rubber (O-ring) on the rear of front bezel. This design allows sealing the front bezel and customer’s fixture to prevent water and dust from entering the enclosure.

Assembly Diagram

Front IP65 Mounting Kit

Front IP65 Mounting Kit consists of M4 screws. The number of screws supplied varies by Panel PC size.
Note: The thickness of the screw depends on customer's fixture.

Installation Step

Step 1
Make a cutout on the fixture (ex. wall) according to the cutout dimension of the Panel PC.
Note: All installation processes will be done from the rear side of the fixture.

Step 2
Based on the drawing, mark screw holes on the rear side of the fixture. Place the Panel PC on the fixture from the front side. The sides of the bezel should be visible from the outside.